- GENIE Keyless Entry
- (Non-Intellicode model)
Back to L.I. Locksmith Home Page
Before you begin
This keypad requires a "PIN" code and a "DOOR" code to operate. You
will need to have both of these codes ready to program the keypad.
"PIN" code - this is the number that will be used to open / close the garage
door. This number is chosen by the user. It can be up to 8 digits (we recommend not less
than three)
"DOOR" code - This number will make the keypad compatible to
the operator. It is determined by viewing the table and converting the dip switches in the
unit or remote, into a three or four digit code.
- Looking in the receiver or in the transmitter, find the dip switch board,
you may have 9 or 12 switches. Break these up into groups of 3. (if you have 9 switches
you will have 3 groups. If you have 12 switches you will have 4 groups). Using the table
below convert each group of three switches to a number. THIS 3 OR 4 DIGIT NUMBER WILL
BE YOUR DOOR CODE.
| UP |
UP |
UP |
= 7 |
- Example:
- If switches 1-3 are in the "up" position that group converts to
number 7.
|
| UP |
UP |
Down |
= 6 |
| UP |
Down |
UP |
= 5 |
| UP |
Down |
Down |
= 4 |
| Down |
UP |
UP |
= 3 |
- SAMPLE:
- Dip switch settings U U U D D U D D D U D U = door code 7 1 0 5
|
| Down |
UP |
Down |
= 2 |
| Down |
Down |
UP |
= 1 |
| Down |
Down |
Down |
= 0 |
Setting a combination from scratch:
- Holding down the "#" and the "8" buttons simultaneously slide cover
up until light comes on and release buttons. This clears all existing information stored
in keypad.
- Press 3, 5, 7 and # buttons (red light should flash once per second)
- Enter your "PIN" number into the keypad followed by the # button (light should
blink faster).
- Enter your three or four digit "DOOR CODE" followed by the * button (light
should go out). Slide cover down.
- To use / test your keypad, slide cover up, enter your "PIN" number followed by
the * button. Door should operate.
E-Mail us
any questions or comments you may have
- L. I. LOCKSMITH & ALARM CO., INC.
- "Your Security Technology Company"
- 26 WEST OLD COUNTRY ROAD - HICKSVILLE NY 11801 (516)
931-2273 Fax: (516) 931-7334