| Step 1 -
Clear the lock |
- Lock the knob and place the Slide Switch
in the down position.
- Remove one of the four AAA batteries and
then turn and hold the knob for at least 2 seconds.
- Re-install the battery. The Lock will beep
16 times.
- Wait 2 minutes before proceeding
(do not touch the button
or turn the knob!).
|
| Step 2 - Set
the Primary Code |
- Turn the Knob, then release when the
display shows "0".
- With the display flashing "0",
press and hold the Code Button until a "P"
is displayed.
- Release the Button and promptly turn the
Knob to enter the new Primary Code (do
not let the display turn off when entering the code).
- Test the Primary Code. You should get a
flashing "0" which means the Primary
Code is correct and that the Alternate Code must still be entered.
|
| Step 3 - Set
the Alternate Code |
- Place the Code Select Switch in the up
position and re-enter the Primary Code. When the flashing "0"
appears, press and hold the Code Button until a "P"
is displayed.
- Release the Button and promptly turn the
Knob to enter the new Alternate Code (do not let
the display turn off).
- With the Switch up, both codes will work.
With the Switch down, only the Primary Code will work.
|
| |
| Step 1 -
Clear the lock (if you know the existing code, you may go to step 2) |
- Remove one of the four AAA batteries and
then press and hold the Code Reset Button for at least 5 seconds.
- Re-install the battery. The Lock will beep
and the Primary Code will now be reset to 3-1-3 and the Alternate Code to
2-0-2.
|
| Step 2 - Set
the Primary Code: |
- Press and release the Code Button
(the lock will beep and the display bar will
flash "- -
").
- While the bar is flashing, enter the
Primary Code (3-1-3 if you just cleared the lock). The lock will flashback
the current Primary Code followed by a flashing "P".
- Enter a new Primary Code and release the
knob. The display will now flashback the new Primary Code and begin
flashing "P" again.
- If you are satisfied with the code, press
the Code Button to accept. If not, then enter another new code and press
the Code Button after the flashback to accept.
|
| Step 3 - Set
the Alternate Code: |
- Once the Primary Code is accepted, the
display will replay the Alternate Code (2-0-2 if you just cleared the
lock) and then flash an "A"
- Enter a new Alternate Code and wait for
the replay followed by the flashing "A".
- When you are satisfied with the code,
press the Code Button to accept.
- Once the Alternate code is accepted, the
display will begin flashing the Display Speed ("3"
if you just cleared the lock).
|
| Step 4 - Set
the Display Speed: |
- To increase the display speed increase the
number, and to decrease the display speed decrease the number (9 is
fastest, 1 is slowest).
- Once the speed is set, press the Code
Button to end the programming.
|
