| Operating Instructions |
|
- Turn control knob LEFT (counter-clockwise) to
activate buttons. (control knob is located on outside below buttons and should read
"SIMPLEX").
- Press and release the correct buttons in the proper order.
- Turn the control knob to the RIGHT (clockwise) to open.
- To lock deadbolt models (DL), turn control knob back to
LEFT (counter-clockwise). Latch models (NL) lock automatically.
|
|
| Changing the Combination |
|
Requirements: |
|
- Door to be in open position
- Tools - Allen (hex) Key supplied
- Choose a new combination and write it down. You can use one button or all five for a
combination, but each button can only be used once. You can use two or more buttons
simultaneously.
|
| |
|
|
Procedure: |
|
|
| WARNING: Once
procedure has been started, it must be completed, correctly, or "Lost
Combination" may occur. Finding a lost combination requires complete disassembly of
lock and combination chamber. This should only be done by an authorized professional
service company. |
|
|
- With door in open position, lock the Simplex lock. (latch or deadbolt should be in
extended position)
- Remove the Allen screw from the interior lock housing. (depending on the hand of the
lock, this screw will be found either on the top or bottom of inner housing)
- Fully turn the outside control knob ONCE to the LEFT.
- Enter the existing combination (factory combination for newly installed locks is;
press 2 and 4 simultaneously, release, then press 3) you should feel a click as each
button is pressed. DO NOT TURN CONTROL KNOB
- Insert the Allen wrench into hole from where screw was removed, and depress the change
button. Gently push to the stop position (a slight click should be felt).
- Remove wrench from hole.
- Fully turn outside control knob ONLY ONCE to the LEFT all the way to
stop position. Then release knob. This clears existing combination.
- Enter you new combination, press buttons carefully - a slight click should be felt as
each button is depressed. (see requirements above for picking new combination)
- Fully turn control knob all the way to the RIGHT, to stop position. Latch or Deadbolt
(depending on model) should retract. Then release knob.
- HOLDING DOOR OPEN, Test lock SEVERAL TIMES. Enter new combination and turn control knob
to Right - latch or deadbolt should retract. To lock deadbolt models turn control knob
back to left (Latch models lock automatically when control knob is released). DO NOT CLOSE
DOOR IF UNIT DOES NOT SEEM TO BE WORKING PROPERLY
- If lock opens every time control knob is turned right WITHOUT entering any buttons,
re-start procedure from STEP 5.
- Replace Allen screw in lock housing
|
E-Mail us
any questions or comments you may have